Use In Hazardous Environments; Marking Configuration Examples; Marking For Europe According To Cenelec And Iec; Figure 55: Side Marking Example For Approved I/O Modules According To Atex And Iecex - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver
Pos : 86 /All e Seri en (Allgemei ne Module)/Eins atz in Ex- Ber eichen/Eins atz in explosionsgefährdeten Bereic hen - Übersc hrift 1 @ 3\mod_1224075191281_21.doc x @ 24084 @ 1 @ 1
11

Use in Hazardous Environments

Pos : 87 /Serie 750 ( WAGO-I/O-SYST EM)/Eins atz in Ex- Ber eichen/Ei ns atz ber eic h Serie 750 @ 3\mod_1234272230203_21.doc x @ 27500 @ @ 1
The WAGO-I/O-SYSTEM 750 (electrical equipment) is designed for use in
Zone 2 hazardous areas.
The following sections include both the general identification of components
(devices) and the installation regulations to be observed. The individual
subsections of the "Installation Regulations" section must be taken into account if
the I/O module has the required approval or is subject to the range of application
of the ATEX directive.
Pos : 88 /Serie 750 ( WAGO-I/O-SYST EM)/Eins atz in Ex- Ber eichen/Beis piel hafter Aufbau der Kennz eic hnung - Übersc hrift 2 @ 3\mod_1224157499140_21.doc x @ 24182 @ 2 @ 1
11.1

Marking Configuration Examples

Pos : 89 /Serie 750 ( WAGO-I/O-SYST EM)/Eins atz in Ex- Ber eichen/Kennz eic hnung für Europa gemäß C ENELEC und IEC - Ü berschrift 3 @ 15\mod_1369299645203_21.doc x @ 120210 @ 3 @ 1
11.1.1

Marking for Europe According to CENELEC and IEC

Pos : 90 /Serie 750 ( WAGO-I/O-SYST EM)/Eins atz in Ex- Ber eichen/Beis piel bedruc kung der ATEX- und IEC- Ex-zug elass enen Bus klemmen gemäß C ENELEC und IEC_2013 @ 14\mod_1360569228625_21.doc x @ 111294 @ @ 1

Figure 55: Side marking example for approved I/O modules according to ATEX and IECEx

Figure 56: Printing Text detail – Marking example for approved I/O modules according to ATEX
and IECEx.
Manual
Version 2.0.0, valid from FW/HW Version 03/03
Use in Hazardous Environments 121