Appendix; Mailbox Commands; Übersicht Sortiert Nach Gruppen Und Opcodes; Table 76: Overview Sorted According To Groups And Opcodes - WAGO I/O-SYSTEM 750 Manual

130

Appendix

Pos : 103 /Alle Serien (Allgemei ne M odul e)/Ü bersc hriften für all e Seri en/Anhang - Übersc hrift 1 @ 4\mod_1239874070437_21.doc x @ 30560 @ 1 @ 1
12 Appendix
Pos : 104.1 /Serie 750 ( WAGO-I/O-SYST EM)/AnhangMailbox-Befehle_750-644_Bes chr eibung _wie_Übersc hriften @ 17\mod_1389172404875_21.doc x @ 140628 @ 2332 @ 1
12.1

Mailbox Commands

This section provides an overview of all available Mailbox commands, sorted
according to groups and opcodes (see appendix "Overview Sorted According to
Groups and Opcodes") and according to Mailbox commands (see appendix
"Overview Sorted According to Mailbox Commands").
Which commands can be executed with which mailbox size is indicated by
symbols as follows:
Available
●
The command can be executed.
Available to a limited extent
(●)
Execution of the command is possible, but only as much data as is possible
for the current mailbox size is returned.
- Not available
The command cannot be executed.
12.1.1 Übersicht sortiert nach Gruppen und Opcodes

Table 76: Overview sorted according to groups and opcodes

Mailbox commands
General commands
IDLE
Block transfer
DLD_START
DLD_CONT
DLD_END
Maintenance and firmware
RebootHost
FlashRebootHost
GetHostFwVersion
GetBbFwVersion
Op-
Description
code
0x00 No job
0x01 Download start of a
block
0x02 Continue block
download or upload
0x03 End block download
or upload
0x10 Warm boot of the
®
Bluetooth subsystems
0x11 Save configuration with
subsequent warm boot
0x12 Read host firmware
version
0x13 Read firmware version
of the baseband
controller
Version 2.0.0, valid from FW/HW Version 03/03
WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver
Length Length
inquiry response
2 2
6 3
2/6/12/ 6/12/
18 18
5 6
2 2
2 2
3 6
2 6/12
May be
executed with
Mailbox
6 12 18
● ● ●
● ● ●
● ● ●
● ● ●
● ● ●
● ● ●
● ● ●
(●) ● ●
Manual