Example Configuration; Example Configurations Via Wago-I/O-Check; Startup With The Bluetooth ® Parameterization Dialog; Network Configuration - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver
Pos : 80 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Inbetri ebnehmen - Konfigurier en - Parametri eren/Beis piel konfiguration - Ü berschrift 1 @ 13\mod_1344242119446_21.doc x @ 101390 @ 1 @ 1
9

Example Configuration

Pos : 81.1 /Serie 750 (WAGO-I/O-SYST EM)/In Betrieb nehmen/Anwendungsbeis piel e 750-644: Bus kl emme-zu- Bus kl emme @ 16\mod_1376563253269_21.doc x @ 129040 @ 23445554344555555555 @ 1
9.1

Example Configurations via WAGO-I/O-CHECK

9.1.1 Startup with the Bluetooth
This section describes startup and configuration of 750-644 I/O modules using the
WAGO-I/O-CHECK software.
The following example demonstrates startup for the minimum configuration and
does not describe the entire functionality. The purpose of these instructions is to
configure simple peer-to-peer communication between two 750-644 I/O modules.
One 750-644 I/O module functions as the master and the other as a slave.
9.1.1.1

Network Configuration

Figure 40: Hardware configuration

1. Similar to the figure "Hardware configuration", set up two identical bus
nodes:
•
•
•
2. Connect one of the fieldbus controllers to an open serial port on your PC
using a WAGO communication cable (750-920).
3. Connect the second fieldbus controller in the same way to another PC serial
port.
Manual
Version 2.0.0, valid from FW/HW Version 03/03
750-841 ETHERNET fieldbus controllers
®
750-644 Bluetooth
RF Transceivers (750-644 I/O modules)
750-600 end modules
Example Configuration
®
Parameterization Dialog
91