Device Description - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver
Pos : 21 /All e Seri en (Allgemei ne Module)/Ü berschriften für alle Serien/Gerätebesc hreibung/Gerätebeschr eibung - Übersc hrift 1 @ 3\mod_1233756084656_21.doc x @ 27096 @ 1 @ 1
4

Device Description

Pos : 22.1 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Ei nlei tung/Anwendung/SO/Anwendung 750-0644 @ 15\mod_1365146295004_21.doc x @ 116599 @ @ 1
The Bluetooth
module, is used to integrate a Bluetooth
SYSTEM 750. 750-644 modules are installed and used jointly with other I/O
modules of the WAGO-I/O-SYSTEMs 750 in different fieldbus systems.
The 750-644 I/O module permits wireless exchange of data within the Bluetooth
piconet. It can function as the coordinator (referred to in the following as the
"master") or as the terminal (referred to in the following as the "slave") depending
on the configuration. A maximum of seven slaves may communicate with one
master.
In piconets consisting of 750-644 I/O modules exclusively, the I/O modules can
use a specific proprietary profile for communication. If using the WAGO 758-912
antenna, ranges of up to 1000 meters can be achieved. In addition to particularly
robust, deterministic radio communication, expanded diagnostic functions are also
available.
The 750-644 I/O module can communication with devices from different
manufacturers that support the protocols of the SPP profile, i.e. the wireless
transmission of serial interface data. Apps are available that allow smartphones to
exchange data with the 750-644 I/O module.
The WAGO-I/O-CHECK software is used to configure the 750-644 I/O module
locally (network configuration, process image mapping). Eight 3-color LEDs
indicate the current status of the 750-644 I/O module.
Pos : 23 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Pos : 24 /Serie 750 ( WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Ei nlei tung/Ei ns atz ber eich/Ei ns atz ber eich 750- xxxx nur Koppl er/C ontr oller aus Kompatibilitätsliste @ 4\mod_1242389440265_21.doc x @ 33262 @ @ 1
The 750-644 module can be used with the fieldbus couplers and controllers of the
WAGO-I/O-SYSTEM 750 of the specified version or higher listed in the
"Compatibility list" table.
Pos : 25 /Serie 750 ( WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Ei nlei tung/Ei ns atz ber eich/Kompatibilitätslisten/Kompati bilitätsliste 750-0644 @ 18\mod_1390827073962_21.doc x @ 143418 @ @ 1
Manual
Version 2.0.0, valid from FW/HW Version 03/03
®
RF Transceiver 750-644, hereafter referred to as the 750-644 I/O
Device Description
®
network (Piconet) in the WAGO-I/O-
19
®