Reference For Mailbox Commands - WAGO I/O-SYSTEM 750 Manual

138 Appendix
Pos : 104.3 /Serie 750 ( WAGO-I/O-SYST EM)/AnhangReferenz-M ailbox-Befehl e_750- 644_ÜohneC ode @ 17\mod_1386253838762_21.doc x @ 139570 @ 234344434444 @ 1
12.3

Reference for Mailbox Commands

In this section, the requirements for the execution of each Mailbox command in
question are represented as follows:
Mailbox size (6, 12 or 18 bytes)
● Available
The command can be executed.
(●) Available to a limited extent
Execution of the command is possible, but only as much data as is possible
for the current mailbox size is returned.
- Not available
The command cannot be executed.
Operating mode (Configuration/real-time or ad-hoc communication)
● Available
The command can be executed.
- Not available
The command cannot be executed.
Device role (master, slave)
● Available
The command can be executed.
- Not available
The command cannot be executed.
Save configuration
● With this command, module settings are changed. This change is first
undertaken on a temporary image of the module configuration. The temporary
image is loaded during a restart of the 750-644 module from the non-
temporary image (flash memory). Changes must be applied to the non-
temporary image so that they remain after a cold start or power loss. To
update the non-temporary image, perform a warm boot (see appendix
"FlashRebootHost"). Alternatively, change the operating mode (see appendix
"setLocalOperationMode"). A warm boot is automatically performed (see
figure "Saving the configuration").
- No data are saved for this command.
Reboot
● The 750-644 I/O module performs a restart after executing the command.
- The 750-644 I/O module does not restart after executing the command.
WAGO-I/O-SYSTEM 750
750-644 Bluetooth
Version 2.0.0, valid from FW/HW Version 03/03
®
RF-Transceiver
Manual