Network Configuration; Startup Of The 750-644 I/O Modules; 9.1.2.2.1 Switching On The Mailbox; Figure 48: Display Bluetooth ® Output Data - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver
Configuration program
The WAGO-I/O-CHECK configuration program is a convenient tool you can use
to enter/execute Mailbox commands as hexadecimal opcodes and to view the
result in the input data. You can obtain the software on a CD-ROM with item
number 759-302 from WAGO Kontakttechnik GmbH & Co. KG.
Mailbox commands
Mailbox commands are executed when a new opcode is entered and/or when the
toggle bit is changed.
9.1.2.1

Network Configuration

In the following example, a master with four slaves is configured. There should be
five 750-644 I/O modules in your network.
9.1.2.2

Startup of the 750-644 I/O Modules

Parameterization in "Configuration" mode only!
Make sure that the 750-644 I/O modules are in "Configuration" mode.
1. Click [Identify] in WAGO-I/O-CHECK to display your node graphically.
2. Right-click on a 750-644 I/O module. Select Process Data in the context
menu. The process data dialog opens.
In the process data dialog, right click on the word Bluetooth
3.
Transceiver in the table header of the dialog.
Select Output Data in the context menu:
4.
Figure 48: Display Bluetooth

9.1.2.2.1 Switching On the Mailbox

1. Switch on the Mailbox for all 750-644 I/O module by setting the control
byte to 0x20 (bit 2
Manual
Version 2.0.0, valid from FW/HW Version 03/03
®
output data
5
= 1) (see table "Switching on the Mailbox").
Example Configuration
®
RF
99