Table of Contents
Advertisement
Operation
Controls
Keys
− The machine is fitted with 2 keys and 1 lamp:
− ON button (1)
If the machine is shut down by End of work /
Shutdown, it remains in timer mode until the
next automatic startup. If the machine must be
switched on in-between press the ON button.
The machine will then start up. Apart from this,
a reset can be triggered by pressing the ON
button.
− The timer lamp (2) lights up if the machine is in
timer mode after Shutdown.
− Film stop key (3) for the emergency stop in
case of a (suspected) film jam. The film is
stopped during the scanning (order interrupted
and Reset of the whole machine). The reset
pop-up is shown on the screen with the button
Yes. Be sure to wait with the confirmation until
the paper transport in the Printer is empty.
− Automatic start: See Automatic Switch-on
(Timer) in this Register
− See also Explanation of the keys to be used in
case of an error: Film stop and ON key, Stop
button on the screen in Register 7.
Touch Screen Monitor
The d-lab is operation is menu supported via
touch screen monitor. The functions are activated
by touching the touch-sensitive Buttons on the
screen.
Specifications:
− 15 inch screen
− SVGA resolution 1,024 x 768 pixels
− Screen-refresh frequency > 75 Hz
An LCD flat screen is available as an option:
Type 8060 / 341
Also refer to the sections Screen Structure,
Buttons and Menu Overview in this Register
AGFA d-lab.3
1 ON button
2 Timer lamp
3 STOP (Film stop key)
2003-06-01 /PN 9008
Overview
dlabr177
Monitor
2.15
Advertisement
Table of Contents
