Maintenance Schedule And Maintenance Intervals - AGFA d-lab.3 Technical Documentation Manual

Operation

Maintenance Schedule and Maintenance Intervals

Weekly Monthly
Daily
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
AGFA d-lab.3
Maintenance jobs to be performed by the customer
Clean APS film carrier
Clean drive rollers in the film carrier area
Clean the film brush
Perform process control on the Paper Processor
Film carrier: To remove dust
Clean film take-up
Clean film chute
Transport unit (TU): Remove paper dust
Single sheet buffer (SR) and sheet bridge (SB): Remove paper dust
Print engine (PE): Remove paper dust
Lane distributor (LD): Remove paper dust / deposits
Sheet transfer (ST) to Paper Processor: Remove paper dust
Paper Processor: Clean tank crossovers, CD feed unit, squeegee
Check solution levels, top up if necessary
Clean chemical filters
Clean densitometer calibration plate
Print chute (LS): Clean transport belt
x Clean exposure filters
x Check solution temperatures
x Clean air filters
– Lamphouse
– CCD fan
– Below cutter units
– Door to print engine (PE)
– Paper Processor, Dryer
x Change scanner lamp (service life approx. 300 h)
x Replace the chemical filters
x Clean processing racks
x Clean dryer rack
x Clean IR dryer
Maintenance
2003-06-01 /PN 9008
8.1