AGFA d-lab.3 Technical Documentation Manual page 299

Operation
Glossary
ACT Area contrast
Buttons Touch-sensitive areas on the Touch Screen
B/W Black and white
Colour steps 1.024 steps per colour
Steps per pixel = RxGxB = 1024x1024x1024 = 1.073.824
DCT Detail contrast
Density steps 1.024 steps
min. density 0,1
max. density 2,1
The human eye can discern differences in low densities better than in high densities.
Dominant Each one of the 4 parameters can be used to influence the effect of the colour under
Parameters correction so that frames / slides / digital images with colour dominants are printed
neutral.
dpi (dots per inch) Resolution of digital images
dTFS digital Total Film Scanning: Measurement of the digital print original
FID Film identification number (film IX240)
LD Lane Distributor
MBL test Master Balance: The MBL test compensates minor fluctuations of the chemistry and
the print lamp.
Package Automatic printing of several print sizes per frame, slide or print file
PBL test Paper Balance: The PBL test compensates the differences among the various paper
types and widths and ensures uniform colour rendering on all paper emulsions in
use.
PE Print Engine (Exposure Unit)
PIKO Pixel Correction: Balancing of the individual pixels of the CCD chip so that the black
value (dark current) and the white value (sensitivity) are identical / reproducible for
the subsequent signal processing.
Pixel Picture elements
RDS Remote Diagnose Service: Remote diagnosis system
RGB Correction values for Red, Green, Blue
SAT Saturation
SB Sheet Bridge
Selector 1 Selector parameter for under-exposed frames
Selector 2 Selector parameter for overexposed frames
Selector 3 Selector parameter for blurred or partly blackened frames (e.g. stray light at the film tip)
Selector 4 Selector parameter for stickers on film (Twin check label)
AGFA d-lab.3
2003-06-01 /PN 9008
Glossary
9.1