Panorama Detection; Color/Density Logic; Tfs Color - AGFA d-lab.3 Technical Documentation Manual

Settings

Panorama Detection

TFS recognizes panorama negatives: The function
must be activated to print panorama sizes.

Color/Density Logic

The buttons TFS Color and TFS Density are only
accessible after the Color/Density logic has been
activated.
This function should always be activated, and
should only be switched off for special test
purposes, e.g. test of the mixed printing.
Note:
Certain parts of the logic are effective even if the
regulators have not been changed.
Recommendation:
Do not change the standard setting.

TFS Color

Dominant parameters
The dominant parameters 1 to 4 can be used to
influence the effect of the color under-correction.
Negatives showing a dominant color are
recognized by the measuring system because the
percentage of the dominant measuring points
exceeds certain thresholds (upper dominant
limits).
Such ranges of measuring points are not taken
into consideration for the calculation of the
exposure data. This is to make sure that negatives
showing a color dominant are printed without a
color cast.
Standard setting:
Step width:
Setting range:
4.38
2003-06-01 /PN 9008
1.0
0.1
0.0 to +4.0
Operation
079
099
AGFA d-lab.3