Maintenance When Required; Removing The Dust From The Lens; Back Printer - Changing The Ink Ribbon - AGFA d-lab.3 Technical Documentation Manual

Operation

Maintenance When Required

Removing the dust from the lens

Compressed air
− Remove the mirror box towards the front
− Pull out the film carrier
− Push the prescanner to the right by hand
− Clean the lens cover glass
− Put back the film carrier and the mirror box

Back printer - changing the ink ribbon

When the printing on the back of the prints gets
too faded, the ink ribbon must be replaced.
− Unscrew the locking screw (1, red) of the lane
distributor (LD).
− Pull out the unit on the telescopic rails.
− Unscrew the knurled screws (2) and remove
the top cover of the back printer.
− Remove the ink ribbon cartridge: Remove it by
slightly pushing in both sides (3).
− Prepare the new ink ribbon cartridge:
If present remove the foil strip on the ink ribbon.
The ink ribbon must be tight in the cartridge; if
necessary tighten by the knob (4) (observe the
direction indicated by the arrow).
− Insert the ink ribbon cartridge.
− Slightly turn the knob (4) on the cartridge until
the cartridge locks in audibly.
− Push in the unit and tighten the locking
screw (1).
AGFA d-lab.3
Maintenance
2003-06-01 /PN 9008
dlabr074
8.29