Wireless Zero Config Utility; To Switch Control To The Wireless Zero Config Utility; To Switch Control To Scu - Honeywell Thor VM1 User Manual

The signal strength for the currently associated/authenticated Access Point is -71 dBm to -90 dBm
The signal strength for the currently associated/authenticated Access Point is -51 dBm to -70 dBm
The signal strength for the currently associated/authenticated Access Point is greater than -50 dBm

Wireless Zero Config Utility

• The WZC utility has an icon in the toolbar that looks like a networked computer with a red X beside it, indicating that
Wireless Zero Config application is enabled but the connection is inactive at this time (the device is not connected to a
network). The WZC icon may not be visible until control is passed to the WZC utility as described below.
• You can use either the Wireless Zero Configuration Utility or the Summit Client Utility to connect to your network. The
Summit Client Utility is recommended because the Wireless Zero Configuration Utility cannot control the complete set of
security features of the radio.

To Switch Control to the Wireless Zero Config Utility

1. Select ThirdPartyConfig in the Active Profile drop down list as the active profile on the Main tab.
2. Warmboot the device.
The Summit Client Utility passes control to Wireless Zero Config and the WZC Wireless Information control panel.
Using the options in the Wireless Zero Config panels, setup radio and security settings. There may be a slight delay
before the Wireless Zero Config icon indicates the status of the connection.

To Switch Control to SCU

1. To switch back to SCU control, select any other profile in the SCU Active Config drop down list, except ThirdPar-
tyConfig.
2. Warmboot the device.
Radio control is passed to the SCU.
8 - 2