Connect Cables; Strain Relief Cable Clamps - Honeywell Thor VM1 User Manual

Connect Cables

There are many cables available for the Thor VM1 including power cables, and data/
communication cables.

Strain Relief Cable Clamps

Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are five strain relief cable clamps secured to the Standard Dock.
There is one strain relief cable clamp and three strain relief brackets for securing cables
to the Enhanced Dock.
Use the strain relief clamps to secure audio, power, and I/O cables attached to the Thor
VM1 dock.
Use the left-most strain relief clamp for the power cable.
To use the strain relief clamp(s):
1. Determine the proper strain relief cable clamp. There are three sizes of cable clamps
2. Remove the strain relief clamp from the Thor VM1 by turning the screw
3. Slide the strain relief clamp over the cable.
4. Using a Phillips screwdriver and the screw that was removed, refasten the clamp
5. Continue in this manner until all cables are secured to the dock.
64
Standard Dock
on the Standard Dock which should be matched to the cable to be secured. For
example, the largest clamp (on the left when viewing the back of the dock) is
designed to secure the power cable. For the Enhanced Dock there is a single cable
clamp. Use this clamp for the power cable, Use the brackets for all other cables.
counterclockwise. Put the screw aside in a safe location.
holding the cable to the Dock. Do not stretch the cable. Leave enough slack in the
cable to allow it to be connected and disconnected easily when needed.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Enhanced Dock