Figure 78: Loosening The Screws On The Ethernet Line Card - Allied Telesis 950 Series Installation Manual

Note
100Gbps transceivers for the AT-XEM2-1CQ line card have
handles. Always use the handles when installing or removing
transceivers.
4. Use a #2 Phillips-head screwdriver to loosen the two screws on the
faceplate of the card. Refer to Figure 78.
Figure 78. Loosening the Screws on the Ethernet Line Card
5. Carefully pull on the screws on the faceplate to disconnect the line
card from the internal connector in the switch. Refer to Figure 79 on
page 138.
x950 Series Installation Guide for Stand-alone Switches
137