Figure 79: Loosening The Screws On The Ethernet Line Card - Allied Telesis x950 Series Installation Manual

Note
100Gbps transceivers for the XEM2-1CQ line card have handles.
Always use the handles when installing or removing transceivers.
4. Use a #2 Phillips-head screwdriver to loosen the two screws on the
faceplate of the card. Refer to Figure 79.
Figure 79. Loosening the Screws on the Ethernet Line Card
5. Carefully pull on the screws on the faceplate to disconnect the line
card from the internal connector in the switch. Refer to Figure 80 on
page 144.
x950 Series Installation Guide for Stand-alone Switches
143