Note
100Gbps transceivers for the AT-XEM2-1CQ Line Card have
handles. Use the handles when installing or removing transceivers.
4. Use a #2 Phillips-head screwdriver to loosen the two screws on the
faceplate of the card. Refer to Figure 124.
Figure 124. Loosening the Screws on the Ethernet Line Card
5. Carefully pull on the screws on the faceplate to disconnect the line
card from the connector on the backplane in the chassis. Refer to
Figure 125 on page 194.
AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
193