Table of Contents
Advertisement
Chapter 3: Installing the Chassis
82
Figure 45. Seating an Ethernet Line Card in the Chassis
6. Visually inspect the line card to verify that its faceplate is flush against
the front panel of the chassis.
7. Tighten the two captive screws on the card to secure it in the chassis.
Refer to Figure 46.
Figure 46. Tightening the Two Captive Screws on the Ethernet Line Card
8. Repeat this procedure to install additional cards.
9. After installing the line cards, go to "Installing Blank Line Card Slot
Covers" on page 83.
Advertisement
Table of Contents
