Figure 52: Seating An Ethernet Line Card In The Chassis; Figure 53: Tightening The Two Captive Screws On The Ethernet Line Card - Allied Telesis AT-SB*908 GEN2 Installation Manual
Advanced layer 3 plus modular switch, alliedware plus v5.4.8-0, virtual chassis stacking, chassis, ethernet line card, fan module, ac/dc power supply
Table of Contents
Advertisement
Chapter 4: Installing the Chassis
98
Figure 52. Seating an Ethernet Line Card in the Chassis
6. Visually inspect the line card to verify that its faceplate is flush against
the front panel of the chassis.
7. Tighten the two captive screws on the card to secure it in the chassis.
Refer to Figure 53.
Figure 53. Tightening the Two Captive Screws on the Ethernet Line Card
8. Repeat this procedure to install additional cards.
9. After installing the line cards, go to "Installing Blank Line Card Slot
Covers" on page 99.
Advertisement
Table of Contents
