Table of Contents
Advertisement
Chapter 3: Installing Power Supplies and Optional XEM2 Line Card
78
4. When the line card makes contact with the internal connector in the
switch. gently press on the sides of its faceplate to seat it on the
connector. Refer to Figure 37.
Figure 37. Seating the Ethernet Line Card in the Expansion Slot
5. Visually inspect the line card to verify that its faceplate is flush against
the front panel of the chassis.
6. Tighten the two captive screws on the card to secure it in the switch.
Refer to Figure 38 on page 79.
Advertisement
Table of Contents
