Beckman Coulter AutoMate 2500 Series Instructions For Use Manual page 9

Safety Notice
Safety Instructions
Inspect the working environment
To avoid injury, inspect your working environment for edges, corners, or protruding parts
before working on the system.
Avoid moving parts
While the system is in operation, do not touch or go close to any moving parts. Close
protective guards and covers during operation. Failure to close covers correctly can cause
injury or incorrect results.
Disconnect system from the mains when working on electrical cabinet
The electrical cabinet contains live wires even when the main switch is turned off. These
wires have visible, yellow markings near all connection points.
Check locking of safety cover position
When lifting safety covers, lock the cover in the raised position before releasing it to avoid
injury.
Risk of injury caused by heavy load
During installation, you risk injuring your hands, fingers and back while handling heavy
loads. To avoid these risks, carry or transport the system or parts of the system following
the specified transportation instructions.
Avoid contact with sample fluid
Avoid direct contact with patient samples, disposable pipette tips, used caps, any machine
components that come in contact with sample fluids, and liquid waste. Always wear gloves
and other protective gear to protect yourself from infection. Before troubleshooting the
system with open doors and covers, remove patient samples. Handle all liquid waste as
potentially infectious. Some liquid waste can require special treatment before disposal.
Follow your laboratory procedure.
Take measures after contact with sample fluid
If you come into direct contact with sample fluid, thoroughly wash the affected area and
consult a physician. Immediately wipe off any contaminants from the system. Clean the
system using approved liquid disinfectant. After working on the system, clean your hands
thoroughly.
Use non bio-hazardous substitutes only when performing tests
Take protective measures if you have to test the system using patient samples. Use
protective equipment for your eyes, nose, and mouth, such as safety glasses or a visor or
mask.
Wear protective clothing
Wear protective clothing and follow universal precautions as dictated by local or national
regulations (CLSI GP17-A2, ISO15190 or 29CFR 1910.1030).
ix
B67471B