Note
4
To clamp the liner to the internal rewinder:
a. Hold rewinder (3) firmly and turn knob (2) clockwise until it stops.
b. Push liner under a bracket (1) of the rewinder (3) and turn knob (2)
counterclockwise until it stops (refer to
Liner). The rewinder is fully spread, thus gripping the liner firmly.
Figure 2.13 Clamping liner under bracket of rewinder
c. Turn rewinder (3) counterclockwise to wind up and tighten part of the end of the
liner.
d. Close the pinch roller (4) by turning it clockwise and position it centrally to the
liner.
e. Turn lever (7) clockwise to lock the printhead. The label roll is loaded for use in
peel-off mode.
Remove Wound-up Roll with Empty Liner
When the labels are used up and the empty liner is wound around the internal rewinder,
remove the wound up roll.
B67471B
Liner guided below horizontal guide of axle. Do not press down on or fold the liner.
Aliquot Module Operation
Remove the Wound up Roll with Empty
2
Run the System
2-49