Beckman Coulter AutoMate 2500 Series Instructions For Use Manual page 10

Safety Notice
Safety Recommendations
Biological risks and hand injury when removing samples
If it is necessary to remove a sample tube manually from the robot grippers, take care not
to come into contact with the sample.
Contamination by exceeded fill level
Exceeding the maximum fill level can contaminate the device and samples.
Use only input and output drawers for loading and unloading tubes
While the system is running, only use the input and output drawers to load racks and tubes.
Do not reach into the system to manually insert or remove tubes while the system is
running! If you need to remove tubes manually, for example in case of an error, stop the
system first.
Do not enable remote access to any AutoMate 2500 Family product PCs.
Do not enable remote access to any of the AutoMate 2500 Family PCs (including the
Sorting-Drive Plus, Sorting-Drive Professional or iPAW PC) or install any other software!
Doing so can disrupt correct operation of the PC.
California Proposition 65
Warning
California Proposition 65
This product can expose you to chemicals known to the State of California to cause
cancer and reproductive harm.
For more information go to https://www.P65Warnings.ca.gov.
Safety Recommendations
Avoid problems caused by power failure
To avoid the problems caused by a power failure and to protect sample data, we
recommend using a UPS (uninterruptible power supply).
Software restart mandatory after intended or unintended power interruptions
After any intended or unintended power interruption, be sure to restart the software and
to perform a complete system initialization.
Equipment damage due to failure to meet power requirements
Before connecting the system to the power line, check that the voltage and frequency
ratings of your power line match those indicated on the device label.
x
B67471B