Run the System
Aliquot Module Operation
— over the two rolls of the pendulum guide (5)
— under the axle (6)
— through label sensor in print unit (refer to
— around the dispensing edge (9)
— through the pinch roller (7) and rewind assist roller (8)
Insert Label Strip into the Printhead
Figure 2.11 Guide a label strip through the printer label sensor
1
Printhead locking lever
4
Print roller
1
Turn the printhead locking lever (1) counterclockwise to lift the printhead.
2
Guide the label strips below the axle (3) and through the label sensor (2). The strips exit
the print component between the printhead and the print roller.
3
Guide the liner below the horizontal guide of the axle (3) (side view).
Figure 2.12 Liner guided below horizontal guide of axle (side view).
2-48
Insert a Label Strip into the Printhead
2
Label sensor
5
Printhead
3
Axle
)
B67471B