Beckman Coulter AutoMate 2500 Series Instructions For Use Manual page 83

Figure 2.10 Guidance of the roll in peel-off mode
1 Core adapter
4 Internal rewinder
7 Pinch roller
10 Printhead locking lever
In peel-off mode, the labels are removed after printing. The empty liner is rolled up on the
internal rewinder (4).
1
Load the label roll onto the core adapter (1) as shown above.
2
When applying the new roll, press down on the cardboard roll in the middle. Never
apply force to the outside of the roll.
3
Unwind about 60 cm (2 feet) of the liner for peel-off mode.
4
Push the label roll downwards.
5
Lift the pinch roller (7) off the rewind assist roller (8) by turning it counterclockwise.
6
Turn the printhead locking lever (10) counterclockwise to lift the printhead.
7
Remove labels from the first 100 mm (approx. four labels) of the liner.
8
Guide the liner along the following feed path to the internal rewinder (4):
B67471B
2 Bracket
5 Pendulum guide
8 Rewind assist roller
Run the System
Aliquot Module Operation
3 Turn knob
6 Axle
9 Peeling edge
2
2-47