500-Sheet Drawer (2Tm)-Lower Media Transport Roll Assembly Removal - Lexmark X850e Service Manual

7500-XXX
2X 500-sheet drawer (2TM)—lower media transport roll assembly removal
1.
Open the 2TM/TTM left door assembly.
2.
Remove the two screws securing the lower bracket (A).
3.
Disconnect the connector from the lower bracket (A).
4.
Remove the large e-clip securing the 2TM/TTM media transport roll assembly (B).
5.
Remove the bearing (C).
6.
Move the 2TM/TTM media transport roll assembly (B) to the right and outward in the direction of the arrow.
7.
Remove the 2TM/TTM media transport roll assembly (B).
Note: One of the bearings may become detached.
8.
Remove the two e-clips with a prying tool on the 2TM/TTM media transport roll assembly (B), the gear (D),
and the bearing (C).
Note: When removing the 2TM/TTM media transport roll assembly (B), do not touch the rubber surface.
E-clip
E-clip
Note: Before re-installing the 2TM/TTM media transport roll assembly (B), do not touch the rubber surface.
4-40
Options Service Manual
A
D
C
B
Connector
Left
E-clip
C