Cartridge Or Photoconductor Error Service Check - Lexmark MX910de Service Manual

Error code Description
51 The flash memory is defective.
52 The flash memory is insufficient.
53 Unformatted flash was detected.
54 The printer was not able to connect with the
network.
55 The internal option installed is unsupported.
56 The parallel port, serial port, or standard USB port is
disabled.
57 Some held jobs were not restored due to
configuration change.
58 Excess number of options detected:
• Too many flash or optional firmware cards are
installed.
• Too many input trays are installed.
59 The input option or output option is incompatible.
61 The hard disk is defective.
62 The hard disk is full.
80 The printer requires maintenance. The appropriate
maintenance kit needs to be installed.
82 The waste toner bottle is full or nearly full.
84 The photoconductor supply is low, very low, or
empty.
88 The toner cartridge supply is low, very low, or empty.

Cartridge or photoconductor error service check

Action
Step 1
a
Make sure that the cartridge or photoconductor is installed.
b
Check if the cartridge or photoconductor is supported, and replace if
necessary.
Does the problem remain?
Action
See "Flash memory failure service check" on
page 138.
See "Insufficient flash memory service check" on
page 139.
See "Flash memory failure service check" on
page 138.
See "Network service check" on page
See "Unsupported internal option service check"
on page
See "Disabled port service check" on page
See "Unrestored held jobs service check" on
page 143.
See "Excess options service check" on page
See "Incompatible hardware option service check"
on page
See "Hard disk failure service check" on page
See "Maintenance kit service check" on page
See "Cartridge or photoconductor error service
check" on page
Yes
Go to step 2.
Diagnostic information
135
142.
145.
135.
No
The problem is solved.
7421
140.
143.
144.
145.
146.