Sensor (Adf Media Exit) Static Jam Service Check - Lexmark X651de Service Manual

Step
Check the sensor (ADF document set) for proper operation.
2
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Touch TBD
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
Check the sensor (2nd scan) for proper connection.
3
Is the above component properly connected?
Place an undamaged document in the ADF, and perform a
4
ADF test.
Does the error remain?
Perform a print test using the ADF.
5
Does the problem remain?

Sensor (ADF media exit) static jam service check

Use this procedure for the following jams:
• 294.00
Check the media path.
1
Is the media path free of media or media fragments?
Check the sensor (ADF media exit) for proper operation.
2
1. Enter the Diagnostics Menu.
2. Touch SCANNER TESTS.
3. Touch Sensor Tests.
4. Observe the line "sensor (ADF media exit)"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked?
Check Yes
Go to step 6. Go to step 5.
Replace the Replace the
sensor (ADF connection.
document set).
Go to
"Sensor
(ADF document
set) removal" on
page 4-78.
Replace the ADF Problem resolved.
controller card
assembly.
Go to
"ADF
controller card
removal" on
page 4-62.
Go to step 5.
Contact next Problem resolved.
highest level of
tech support.
Go to step 2. Remove any
media or media
fragments.
Go to step 4. Go to step 3.
Diagnostic information
7462
Previous
No
Next
Go Back
2-123