Management Operations; Putting Into Service - ABB SACE Tmax XT5 Operation And Maintenance Manual

Management operations

Life cycle The following operations are required to ensure that SACE Tmax XT functions correctly:

1 - Putting into service

General checks Perform the following inspections before putting into service:
17 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Reception
Figure 9
Operation
Reception
Installation
Putting into service
Maintenance and faults
Decommissioning
This document describes the Putting into service and Maintenance and faults operations for Ekip Touch;
consult the Installation Instructions and Technical catalog for the other operations (references on page 4).
Wizard When powered up, Ekip UP displays the Wizard window, a user-friendly procedure for immediate adjustment
of certain parameters: language, date, time, voltage of the installation and PIN.
After the procedure has terminated, the window will no longer appear unless it is reset via Ekip Connect by
the Reset Wizard command: in this case, Wizard will appear when the apparatus is powered up the next
time.
NOTE: for security reasons, ABB strongly advises you to change the PIN right from the first
access and to keep it in a safe place
Points to be
Checks
checked
Earth connections
Main
If present, connection and tightening to external voltage tap offs (V0)
connections
If present, connection of Ekip Supply supply/module
If Ekip Touch is not on, connect an external supply device (example: Ekip TT) to the Trip
Alarm
unit and make sure there are no alarms present (details on page 19).
Parameters Configure all the parameters of the unit as required
Installation Commissioning
Description
Unpacking and inspection of materials received
Assembly operations
General pre-ignition inspections
Routine inspections and cleaning, management of alarms or
faults
EOL treatment and disposal
ABB | SACE Tmax XT
Maintenance Disposal
Management operations | 1 - Putting into service