Ekip Com Ethernet/Ip - ABB SACE Tmax XT5 Operation And Maintenance Manual

9 - Ekip Com EtherNet/IP

Safety and cyber security Since the module allows the actuator connected to Ekip Touch and access to the data in the unit to be
146 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
TM
Ekip Com EtherNet/IP
Ethernet network with EtherNet/IP
functions.
The module is configured as master and remotely, you can:
• read Ekip Touch measurements and information
• manage certain controls, including opening and closing the actuator (MOE-E)
• access information and parameters not available on the display
• If connected to a withdrawable version of the circuit-breaker, the allows the racked-in/racked-out status
to be detected
NOTE: the remote open and close commands of the circuit-breaker can only be executed if
Ekip Touch is in the Remote configuration
The System Interface document is available for mapping the module in its communication network. All the
required communication and command details are listed in the document (page 129.
Depending on the parameter settings, described in the next pages, the ports used by the module are:
Port
44818
44818
2222
68/udp
Accessories Ekip Cartridge and Ekip Supply are required in order to connect Ekip Com EtherNet/IP
Touch (page 130, 131).
checked, it can only be connected to networks equipped with all the necessary security and prevention
measures against unauthorized access (for example, the network of the control system of an installation).
IMPORTANT:
• it is the customer's sole responsibility to provide and continuously ensure a secure
connection between the module and customer network or any other network (as the
case may be). The plant manager must establish and maintain appropriate measures
(such as but not limited to the installation of firewalls, application of authentication
measures, encryption of data, installation of antivirus programs, etc.) to protect the
product, the network, the customer system and interface against any kind of security
breaches, unauthorized access, interference, intrusion, loss and/or theft of data or
information. ABB and its affiliates are not liable for damages and/or losses related to
such security breaches, unauthorized accesses, interference, intrusion, loss and/or
theft of data or information.
• The module cannot be connected directly to the Internet. Only connect to dedicated
Ethernet networks with EtherNet/IP
Models Two different modules compatible with the EtherNet/IP
Ekip Com EtherNet/IP
The modules are identical in terms of characteristics and installation methods, except for: display menus,
cabling and addresses for system communication, which are specific for each module.
NOTE: if different indications are not given, the information in the next chapter is valid for
both models
The two modules can be connected at the same time to Ekip Touch so as to expand the potential of the unit
(e.g. for applications where high grid reliability is required).
IMPORTANT: each Ekip Touch can be fitted with only one module per type. The
configuration with two modules of the same model is not allowed (example: two Ekip
Com EtherNet/IP
is a communication accessory which allows Ekip Touch to be integrated into an
TM
communication protocol, with remote supervision and monitoring
TM
Protocol Notes
Encapsulation Protocol (example: ListIdentity, UCMM, CIP Transport
TCP
Class 3)
UDP 44818 UDP Encapsulation Protocol (example: ListIdentity)
UDP 2222 UDP CIP Transport Class 0 or 1
DHCP Client DHCP client enabled alternatively as Static address = On
Redundant.
TM
Redundant)
TM
communication protocol
TM
protocol are available: Ekip Com EtherNet/IP
TM
External accessories | 9 - Ekip Com EtherNet/IP TM
ABB | SACE Tmax XT
to Ekip
TM
and
TM