ABB SACE Tmax XT5 Operation And Maintenance Manual page 192

Remote Link configurations Regarding the Link functions, the following further parameters are available:
Remote information Additional information can be accessed via the service connector (via Ekip Connect) or via a system bus
Remote Link information Regarding the Link functions, the following further parameters are available:
190 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Information Description
IP address of each actor (from 1 to 15)
Link Actor (1÷15)
Configuration parameters of the configurable states:
• selection of actor (actor from 1 to 15) which activates the
Remote Programmable
programmable status
Status (A÷D)
• event of the actor that determines change of programmable
status
Configuration parameters of the words:
Remote Status word • selection of actor (actor from 1 to 15) from which the word
status is taken
(A÷D)
• selection of the taken word
Active (Passive diagnosis) or deactivated (No diagnosis) cabled
Diagnostic
selectivity diagnosis
30 s, 1 min, 10 min, 60 min diagnosis frequency intervals
Diagnostic check timeout
available, if activated
Configuration of hardware selectivity (Only HW) or hardware and
Zone Selectivity Type
logic (Mixed)
Repeat Configuration Interactive mask for selecting selectivity to be sent also to the
upper levels, even if not active in the programmed device
mask
communication:
Information
HW and Boot version
Flash CRC status and result
Ekip Link status
SNTP Server Error
SNTP Server Synchronization
IEEE 1558 status
Information
Line Congruency detection
Remote Programmable Status
Remote Status Word
Logic Zone Selectivity
Description
general module information
Information about the correctness of the SW in the module
Signals Ethernet cable connection errors
Error in communication with SNTP server
State of synchronism with SNTP server
Valid with Master IEEE 1588= ON, notifies the presence (Slave or PTP
Master Active) or absence (PTP Master but Passive) of the higher level
master
Description
Information about the state and inconsistency of HW and logic
selectivity (state and type of selectivity inconsistent)
state (true/false) of remote programmable states A, B, C and D
value of remote programmable Words A, B, C, D
Logic selectivity states (inputs and outputs)
ABB | SACE Tmax XT
Default
0.0.0.0
Actor 1
Nobody
None 1
global
No
Diagnostic
30 seconds
HW only
0x0000
Internal accessories | 6 - Ekip Link