Ekip Cartridge - ABB SACE Tmax XT5 Operation And Maintenance Manual

2 - Ekip Cartridge

Connections Ekip Cartridge has two terminal boxes:
Mounting To connect the module to Ekip Touch, please consult document 1SDH002009A1503.
130 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Ekip Cartridge is an external accessory. It can be installed on standard 35 mm DIN rail (DIN EN 50022 type
TS 35x15 mm) and allows Ekip Touch to be connected to other external accessories:
• all cartridge modules (e.g.: Ekip Supply, Ekip Com, etc)
• contact for signaling racked-in/racked-out state, in the case of withdrawable CBs
Models The two different models available allow two or four modules to be connected, respectively.
IMPORTANT: one of the modules must always be Ekip Supply
Figure 39
Connector Description
Terminal for connecting the racked-in/racked-out status contact.
1
Terminal for connecting Ekip Cartridge to Ekip Touch.
A list and description of the Pins is given below:
• K2: Supply output for Ekip Touch (+24V DC)
2
• K1: Supply output for Ekip Touch (-24V DC)
• W3: CAN Bus
• W4: CAN Bus
Access to all the external connections is available in the respective modules, on the upper side of Ekip
Cartridge.
NOTE: Ekip Cartridge is supplied by default with a jumper on the terminal
To use the racked-in/racked-out status signal, remove the jumper in the connector
and connect the cables from the fixed part of the CB.
ABB | SACE Tmax XT
External accessories | 2 - Ekip Cartridge