ABB SACE Tmax XT5 Operation And Maintenance Manual page 195

Remote configurations Additional parameters can be accessed via the service connector (via Ekip Connect) or via a system bus
Remote information Additional information can be accessed via the service connector (via Ekip Connect) or via a system bus
193 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
communication:
Information Description
Allows the CRL (Certificate Revocation List) to be used to ascertain whether the
CRL Enable
server certificate is valid
Clock update
Enables control of the time reference transmitted by the SNTP server
hardening enable
Enables the position of the SNTP server to be set in relation to the network in which
SNTP Server
the module is installed
Location
Defines the time zone to be used for synchronism
SNTP Time zone
Used to select whether daylight saving time is present (ON) or not (OFF) in the
SNTP Daylight
country to which the synchronization time refers
Saving Time
Permits (Enabled ARP) the periodic generation of a Gratuituos ARP message, used
Disable Gratuitous
by Ekip Connect to rapidly find the modules via Ethernet scan without knowing the
ARP
IP address beforehand
communication:
Information Description
HW and Boot version general module information
Flash CRC status and
Information about the correctness of the SW in the module
result
Publish enable
Enable status in Security File
configuration
Name of the file dedicated to the information to transmit (measurements, etc.)
Configuration file
Name of the file dedicated to the information requested by the module for
Security file
transmission purposes (addresses, certificates, etc.)
Certificate Revocation
name of file containing revoked certificates
List
name of the executable firmware update file
Executable file
Configuration error error status of module configuration
Sample time period of data acquisition from the connected devices
Log time period within which the acquired data are saved in the log
Upload time period (calculated by the module) between each data transmission
Configured device Number of modules involved in the network with Hub module
Polling period API events period with which the module communicates with the API device
Connection client 1, 2, 3 Address of TCP modbus clients connected to the module
Recordings of the latest saving operations and percentage of resources being
Statistics
used
Status plant side Information about the quality of the communication with the other devices
State of the errors concerning the TLS session established between module
Status Cloud side
and server
Application status operation progress indicators
General indicators of the module: SNTP status, flash, cable connection, FW
Status
availability, file errors, etc.
ABB | SACE Tmax XT
Internal accessories | 7 - Ekip Com Hub