ABB SACE Tmax XT5 Operation And Maintenance Manual page 36

Installation menu If Ekip Touch detects that Rating Plug or Ekip Measuring have not been installed properly, it signals an alarm
Test Menu
About Menu
34 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
(page 19) and completes Settings menu with the specific installation section:
Menu Submenus 1
Circuit Breaker Installation
Correct installation is confirmed by a message on the display and disappearance of the alarm signal and
installation menu.
NOTE: availability of submenus depends on the module, which appears to have not been
installed
Menu Submenus
Autotest -
-
Trip Test
Test CB -
Ekip CI -
Ekip Signalling 2K-1
Ekip Signalling 2K Ekip Signalling 2K-2
(1)
Ekip Signalling 2K-3
S Protection
ZoneSelectivity
(2)
G Protection
(1)
available if one or more Ekip Signalling 2K modules are connected and detected by Ekip Touch
(2)
available if Ekip Touch is on with auxiliary supply
(3)
available with S and/or S2 protection enabled and curve t=k
(4)
available with G and/or Gext protection enabled and curve t=k
Menu Submenus
Protection Unit -
Circuit Breaker -
IEC61557-12 -
(1)
Feature Collection -
Modules Modul x
Load Input Status
Power Controller (3)
Load Active
Load Input Status
Load shedding (3)
Load Active
(1)
available if Class 1 Power & Energy Metering SW package is provided for by Trip unit module or if it has been
previously activated
(2)
available if one or more modules are connected and detected by unit
(3)
available if function has been installed and enabled in Trip unit
Submenus 2
Rating Plug
Ekip Measuring
Description, parameters
and Commands
Autotest command
TRIP command
Close CB, Open CB
Autotest command
(1)
Module autotest command
(1)
(1)
Input, Force Output, Release Output
Information provided
Information about Ekip Touch: Mainboard serial
number, Trip unit serial number, type, version,
standard, SW version, date and time, language
CB information: TAG name, CB name, rated current,
number of poles, CB status and position, total
operations, CB serial number
Status of 1% measurements (from Class 1 Power
& Energy Metering package), serial number of
assembly and current sensors connected
List of tripped protections in Trip unit
Module information: serial number, SW version,
(2)
status of inputs/outputs/contacts (if present)
Status of loads (open/closed)
Load configuration (activated/not activated)
Status of loads (open/closed)
Load configuration (activated/not activated)
ABB | SACE Tmax XT
Commands
Install
Install
Page
120
120
120
121
121
121
Interface and menus | 4 - Menu