ABB SACE Tmax XT5 Operation And Maintenance Manual page 143

Connections For references about the connection and terminals, please consult document 1SDM000005A1001; a cable
Power supply Ekip Com Modbus TCP is supplied directly by the Ekip Supply module to which it is connected.
Interface the module has three signaling leds:
Mode The two operating modes available can be configured via the menu:
141 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
of the Class 6 S/FTP type (Class 6 with double screening S/FTP) must be used for the communication bus.
To connect the module to Ekip Supply and Ekip Cartridge, please consult document 1SDH002009A1503.
NOTE: communication between Ekip Touch and the module is interrupted in the absence of
auxiliary power supply
Figure 46
LEDs Description
Signals the on status and correct communication with Ekip Touch:
• off: module off
• on steady or flashing synchronized with the Power led of Ekip Touch: module on and
Power
communication with Trip unit present.
• flashing not synchronized with the Power led of Ekip Touch (2 fast flashes per
second): module on and communication with Trip unit absent.
Indicates the communication state:
Link (1) • off: incorrect connection, signal absent.
• on steady: connection correct
Indicates the communication state:
Activity (2) • off: no activity on line
• flashing: activity on line present (receiving and/or transmitting)
Mode Description
Information and commands are managed by single requests/queries according to
Modbus TCP
Modbus TCP protocol rules and mapping (see System Interface)
Information and commands are available in a web page, which can be accessed via
a browser by entering the IP Address of the module as the address.
HTTP Server
The page has a login window where the user is requested to enter the same user
password as the one requested on the display for editing parameters.
2
ABB | SACE Tmax XT
1
External accessories | 7 - Ekip Com Modbus TCP