ABB SACE Tmax XT5 Operation And Maintenance Manual page 141

Menu Local bus activation, which is essential for starting the communication between module and Ekip Touch, is
Remote configurations Additional parameters can be accessed via the service connector (via Ekip Connect) or via a system bus
Remote information Certain additional information concerning the version and status of the module is available via the service
139 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
available in the Settings menu (page 33).
Two areas are activated if Ekip Touch detects the module correctly:
• information area in the About - Modules menu, containing the software version and serial number of the
module
• specific configuration area in the Settings - Modules menu, where the following communication parameters
can be configured:
Parameter Description
Module address; 1 to 63 range available
MAC Address IMPORTANT: devices connected to the same network must
have different addresses
Data transmission speed; 3 options are available: 125 kbit/s, 250
Baudrate
kbit/s, 500 kbit/s
63 default of the Ekip Com DeviceNet
(1)
communication:
Parameter Description
Defines the addressing class of the module, either 8 or 16 bits.
Class ID
Defines the behavior of the module following loss of communication
(Bus-Off), with a choice between Standard (supply reset is awaited
Bus-Off
if the communication is lost) and Advanced (the module attempts to
Behavior
reset itself if it detects the error status).
connector (via Ekip Connect) or by communication via system bus; the information includes: HW and Boot
version, CRC status (correctness of the SW in the module).
TM
module; 62 default of the Ekip Com DeviceNet
External accessories | 6 - Ekip Com DeviceNet TM
ABB | SACE Tmax XT
Default
63 / 62
(1)
125 kbit/s
Redundant module
TM
Default
8-bit Class ID
DeviceNet
standard