External Accessories; Introduction And System Interface - ABB SACE Tmax XT5 Operation And Maintenance Manual

External accessories

1 - Introduction and System interface

Operating conditions Ekip Synchrocheck, Ekip Com, Ekip Signalling and Ekip CI function correctly:
System Interface Document 1SDH002031A1101.zip, describing how to use the Ekip Com communication modules correctly,
129 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
• In the presence of auxiliary supply voltage
• With the circuit-breaker in the Racked-in position (if the CB version is withdrawable)
The limitations listed below apply in all the other cases:
Modul / Con- Ekip Synchro-
dition check
Module power Synchronization
supply absent contact: open
CB in Test Synchronism: not
(1)(2)
position available
(4)
CB in
Synchronism: not
DISCONNECTED
available
(4)
position
(1)(3)
(1)
the description refers to the module when correctly on and with the CB in the indicated position
(2)
in the Test position, the Trip unit is connected to the modules and all information is available on the display or
via external communication
(3)
in the Racked-out position, connection and communication between Trip unit and modules is interrupted.
Information is not available/valid
(4)
due to voltage not connected to the internal sockets
(5)
see System Interface, INFORMATION WITH PROTECTION TRIP UNIT DISCONNECTED section (next page)
(6)
the outputs only function correctly if configured as: input status (of module itself) or non-communication with
Trip unit. For all other configurations, the module forces the Outputs as per Contact Type parameter (NO, NC).
is available in ABB library; the file contains:
Document Description
Guidelines with details about how to put the communication modules into
1SDH002031A1101.pdf
service, with reference to the protocols and supporting documents
Table with the references of all the registers for parameters, controls,
1SDH002031A1101.xlsx
measurements, etc.
The .zip file contains the files for supplementing Ekip Touch in the available communication networks, with the
specific Ekip Com module and an IMPORTANT file with notes on how to use the files:
File
(1)(2)
ABBS0E7F.gsd + EkiDPB.bmp
Ekip_COM_EtherNetIP_M4_v03_06.eds
Ekip_COM_DeviceNet_v02_08.eds
ABBEC0304_Ed1.icd
ABBEC0304_Ed2.icd
GSDML-V2.3-ABB S.p.A.-Ekip Com
Profinet-20180823.xml
(1)
The files are also valid for the respective Redundant versions.
(2)
Check the Firmware version of your module so as to choose the file with the correct configuration.
Ekip Com Ekip Signalling
Communication: Output contacts:
absent open
Communication: Inputs and output
active contacts: available
Inputs and output
Communication:
contacts: partial
partially active
(5)
available
Protocol / Ekip Com module
File .gsd and module image for configuring Ekip Com Profibus
DP
File .eds for configuring Ekip Com EtherNet/IP
File .eds for configuring Ekip Com DeviceNet
File .icd for configuring Ekip Com IEC 61850
File .xml for configuring Ekip Com Profinet
External accessories | 1 - Introduction and System interface
ABB | SACE Tmax XT
Ekip CI
Output contact:
maintains previous
position
Inputs and output
contact: functioning
Output contact:
maintains previous
position
(6)
TM
TM