ABB SACE Tmax XT5 Operation And Maintenance Manual page 33

Advanced menus The Advanced menu can be used to configure the following protections
31 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Name Parameters
MCR List in dedicated chapter
2I List in dedicated chapter
IU List in dedicated chapter
UV List in dedicated chapter
(2)
OV List in dedicated chapter
(2)
UV2 List in dedicated chapter
(2)
OV2 List in dedicated chapter
(2)
VU List in dedicated chapter
(2)
S(V) List in dedicated chapter
(2)
S2(V) List in dedicated chapter
(2)
RV List in dedicated chapter
(2)
UF List in dedicated chapter
(2)
OF List in dedicated chapter
(2)
UF2 List in dedicated chapter
(2)
OF2 List in dedicated chapter
(2)
RP List in dedicated chapter
(2)
D List in dedicated chapter
(2)
RQ List in dedicated chapter
(2)
OQ List in dedicated chapter
(2)
UP List in dedicated chapter
(2)
OP List in dedicated chapter
(2)
ROCOF List in dedicated chapter
(2)
R STALL List in dedicated chapter
(2)
R JAM List in dedicated chapter
(2)
UC List in dedicated chapter
(2)
U List in dedicated chapter
(2)
PTC List in dedicated chapter
(2)
V DIR, VINV List in dedicated chapter
(2)
59 S1 List in dedicated chapter
(2)
VS Warning, FS Warning, FW1
Warnings
Warning
Threshold 1 I1, Threshold 2 I1,
Signallings Threshold Iw1, Threshold Iw2,
Phase Sequence
External Trip, Trip Reset, Switch
Functions
On SET B
(4)
Synchrocheck List in dedicated chapter
Adaptive Protections
(1)
if the
where the set can be selected (Set A / Set B) will be available before the list of protections (page 67); The only
Advanced
menu always present via
(2)
available if provided for by Trip unit model or if the relative SW package has been activated, where possible
(page 6)
(3)
CosØ available if provided for by Trip unit model or if the Power Protections package has been activated
SET B Adaptive Protections
(4)
available when
Ekip Synchrocheck
(5)
available when
SW package
Standard Protections
Voltage protections
Voltage Advanced protections
Frequency protections
Power protections
ROCOF protections
Motor protections
Interface protections (IPS)
, CosØ
(2) (3)
Standard Protections
(5)
Dual set
package is available and
Functions
is
package is present
is present
ABB | SACE Tmax XT
:
(1)
Page
45
46
47
50
51
51
52
52
53
54
56
57
58
58
59
60
61
64
63
64
63
66
69
69
70
70
71
125
125
125
79
79
76
has been activated, an intermediate menu
Interface and menus | 4 - Menu