ABB SACE Tmax XT5 Operation And Maintenance Manual page 153

Configurations via menu Local bus activation, which is essential for starting the communication between module and Ekip Touch, is
Information in menu The following information will be available in the About-Modules menu if Ekip Touch has detected the module
151 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
available in the Settings menu (page 33).
The following communication parameters can be configured if the module has been correctly detected by
Ekip Touch in the Settings-Modules menu:
Parameter
Static IP address ON
Static address IP address
Static Network Mask
Static Gateway address
Enable SNTP client
SNTP Server Addr.
correctly:
Information Description
Identifier and SW version of the module
SN and version
Address of the module, assigned to the module by a DHCP server at the time
of connection to the network in the case of configuration with a dynamic IP, or
can be set via the menu in the event of a static IP.
IP address
Subnet mask; identifies the method for recognizing the subnet to which the
modules belong and enables modules to be searched for within a defined set
Network Mask
of recipients.
IP address of the node to which the module is connected, in the presence of
Gateway address
several subnets
Address assigned by ABB, with OUI (Organizationally Unique Identifier) equal to
MAC address
ac:d3:64, which uniquely identifies the manufacturer of an Ethernet device
Name of the configuration file uploaded to the modules
Cfg file
Code of the error concerning the configuration file (0 = no error)
Cfg file error
Description
Defines whether the module has a dynamic (Off) IP
address or static (On) IP address
Se = On all the associated parameters are enabled
Enables the static IP to be selected
Enables the subnet mask to be selected
When there are several subnets, enables the IP address of
the node to which the module is connected to be selected
Allows the SNTP protocol for distribution of the clock and
synchronization signal to be enabled.
Allows the network server that supplies the SNTP to be
set.
NOTE: without a DHCP server, the module automatically adopts a
random IP address within the 169.254.xxx.xxx range
ABB | SACE Tmax XT
Default
OFF
0.0.0.0
0.0.0.0
0.0.0.0
OFF
0.0.0.0
External accessories | 10 - Ekip Com IEC 61850