Running the
System
SDC790A
Once a program is selected and material loaded, the F731 is controlled
by the DI900/DI950 Inserting System's control panel. Use the DI900/
DI950 controls to run a Trial Piece and to start and stop continuous
operation.
If the F731 is running an OMR program, three blocks will show on the
display as illustrated below. When running non-OMR jobs, blocks 2 and 3
only will show on the display.
JOB1
PAPER/DF C=1
Count: 00
Block 1
shows that the F731 has read the first scan dash mark on the
page, indicating that the scanning system is functioning.
Block 2
shows that the F731 has confirmed to the Inserter that the
collation on the conveyor is ready for transfer into the
Inserter.
Block 3
indicates that the Inserter has sent back a collation signal to
the F731.
The F731 will continue operation until:
•
You stop it by pressing Stop/Clear Deck (Red).
or
•
You open one of the covers. The safety interlock switch will stop the
machine.
or
•
The material runs out or stalls. In this case the machine will stop
automatically.
TIP:
At the completion of each job run, it is recommended that you check the
two trays in the F733 Outsort Tray for diverted sets.
ORIENTATION 3
Total: 000000 R
Block 1
Block 2
Block 3
Operation • 2
Speed: 100%
2-17