1 • Introduction
Operator
Controls
- F731
1-12
Arrow Buttons <>
1. In the operating mode, scroll through available (up to 99) programs in
the program list.
2. In programming mode, select alpha or numeric characters or other
variable settings.
Run Confirm (Green)
In the programming mode, answers YES to prompts.
After set-up with the pre-run adjustments, operation of the SYSTEM
will be through the DI900/DI950 Inserter control panel. This includes
both single cycle (Trial Piece) and continuous operation.
Exit (Blue)
Used when advancing through options in the programming mode.
Stop/Clear Deck (Red)
In the programming mode, answers NO to prompts; also acts as a STOP
button during continuous operation.
If material is in the accumulation area of the F731 i.e. the last set in a job
run, pressing this button will eject the material through the DI900/DI950
Inserting System.
F731 Universal Feeder Control Panel
SDC790A