Pitney Bowes F731 Operator's Manual page 44

3 • Programming
3-8
Example: 26mm code length with 6 scan lines gives an increment of 26
divided by 5 (the number of gaps) = 5.2mm
Enter this increment using the Arrow Buttons. The figure entered is in units
of 0.01mm i.e. in the example above 5.2mm would be entered as 520. Press
Green to confirm. The display now moves to the scan functions selection:
Use the Arrow Buttons to select the scan functions. For each scan line in
order as printed on the page, select the function required and confirm by
pressing Green.
Examples:
Benchmark control in position 1
Benchmark control
<-->=SELECT
Beginning of collation in position 2
Beginning of collation
<-->=SELECT
Select feed 1 in position 3
Select feed 1
<-->=SELECT
End of collation in position 4
End of collation/present
<-->=SELECT
When the required scan functions are set, press Blue to exit.
HINT:
If you make an error at any time during this process, pressing Red will allow
you to modify your selections.
NOTE:
If your OMR marks are not contiguous (i.e. some mark positions are not
being used), you must define where the unused positions are so that the
system does not interpret the unused positions as an error. After each scan
line function is set, if you wish to insert a gap, press Red, select the number
of scan positions for the gap using the Arrow Buttons and then press
Green to confirm.
UDV (Upstream divert)
<-->=GAP
Green=CONF. Blue=END Red=GAP
Green=CONF. Blue=END Red=GAP
Green=CONF. Blue=END Red=GAP
Green=CONF. Blue=END Red=DEL.
: [ 1]
Green=CONFIRM
: [ 2]
: [ 3]
: [ 4]
: [ 3]
SDC790A