Set The Scanning Head; Side To Side Adjustment Of Omr Scanners - Pitney Bowes F731 Operator's Manual

2 • Operation
Set the Scanning
Head
Side to Side
Adjustment of
OMR Scanners
2-6
The Scanning Head is used to read OMR/BCR/OCR/2D Matrix scan marks
printed on your material. If you are using this option, carry out the following
settings. If you don't use this option, continue with 'Setting the Material
Guide Fingers' on page 2-10.
Bottom Scanning
Connect power and turn ON. Open the Top and Front Covers.
Open the separator. Unlock lever
a, turn knob b clockwise as far as
it will go and hold in position while
locking lever a.
The OMR scan marks are read from the underside of the sheet and so to be
able to set the scanner position, you must mark their position on the upper
face of the sheet.
Slide a sheet under the separator
and observe the scanner beam on
the sheet.
Adjust the scanner side to side until
the beam is centred on the scan
marks. Use the top adjusting knob
for rear scanning and the lower
knob for front scanning.
Close the covers.
SDC790A