Side To Side Adjustment Of Bcr Scanners - Pitney Bowes F731 Operator's Manual

2 • Operation
Side to side
Adjustment of
BCR Scanners
2-8
Bottom Scanning
Connect power and turn ON. Open the Top and Front Covers.
Open the separator. Unlock lever
a, turn knob b clockwise as far as
it will go and hold in position while
locking lever a.
The BCR marks are read from the underside of the sheet and so to be able
to set the scanner position, you must mark their position on the upper face
of the sheet.
Press the Green, Blue and Red buttons at the same time to enter the Menu.
Use the Arrow Buttons to select 'User Menu', then press Green to confirm.
Use the Arrow Buttons to select 'BCR Test', then press Green to confirm.
If your system has more than one BCR scanner, use the Arrow Buttons to
select 'BCR Location', then press Green to confirm. Select the location of
the scanner you wish to test, then press Green to confirm.
Slide a sheet under the separator
and observe the scanner beam on
the sheet.
Adjust the scanner side to side until
the marks are centred on the beam
area.
Unscrew the locking knob 1. Grasp
handle 2, slide the scanning head
out and reposition the scanning
head. Slide the unit back into the machine and check the alignment.
When in 'BCR Test', the scanner red lights will flash slowly. If the code is
read successfully i.e. the scanner is correctly aligned, the lights will flash
faster and the characters read will display on the operator display.
When the scanner is positioned correctly, tighten locking knob 1.
Exit from the User Menu and close the covers.
2
1
SDC790A