Operator Controls - F734/F735 - Pitney Bowes F731 Operator's Manual

1 • Introduction
Operator
Controls
- F734/F735
1-10
Manual Reverse Button
With ALL covers closed, press and hold the Manual Reverse Button, the
Pressure Assembly will move to the left. Releasing the button will stop
movement of the Pressure Assembly.
When loading material, you will need to move the Pressure Assembly as
far to the left as is required in order to load your material. When the Manual
Reverse Button is pressed, the No Pressure Indicator light will stay ON.
Manual Forward Button
With ALL covers closed, press and hold the Manual Forward Button, the
Pressure Assembly will move to the right. Releasing the button will stop
movement of the Pressure Assembly.
After loading material, you will need to move the Pressure Assembly to the
right until it contacts the material, and the No Pressure Indicator light goes
OUT.
Clear Deck Button
With ALL covers closed, press and hold the Clear Deck Button. The drive
motors will transport any remaining material out of the machine. Under
normal circumstances it is not necessary to use this button, as the material
would automatically feed out into the F731 Universal Feeder. However, at
the end of a material run, if some material remains in the machine, use the
Clear Deck button to remove it.
Stop/Auto Button
Use this button to set the machine for Automatic operation, after loading
the material. Whenever the Auto mode is active, the Automatic Controls
Indicator light will be ON. If a material stoppage is detected on the F734/
F735, automatic operation is stopped and all the yellow indicator lights on
the Control Panel will FLASH. To reactivate the Automatic mode, simply
press the Stop/Auto Button once.
When the F734/F735 High Capacity Loader is in Auto mode, pressing this
button will stop it immediately.
Power Indicator
The Power Indicator light will stay ON whenever power is applied to the
machine, and the Main Power Switch is ON.
Automatic Controls Indicator
This light will be ON whenever the machine is in Automatic mode.
No Pressure Indicator
This light will be ON whenever there is insufficient pressure on the material.
SDC790A