Select The Program - Pitney Bowes F731 Operator's Manual

2 • Operation
Select the
Program
2-4
The instructions which follow assume that the program you want is available
from the list in the machine's memory. If necessary, see 'Adding a Non-
Scanning Program' on page 3-2, or 'Adding a Scanning Program' on page
3-5 for programming instructions.
The display will show the last program run on the top line. Use the Arrow
Buttons to scroll through the list of available programs.
To select a program, scroll so it appears on the first line of the display as
indicated by the arrow and <PROG prompt. Press the Green button to

select the program.

New program. Pre run adjustments?
Green=YES
The display asks if you wish to run pre-run adjustments. If this is a new job,
press Green and carry out the adjustments as described on pages 2-5 to
2-13. If it is the current job, or the pre-run adjustments have already been
completed, then press Red.
Material and
Handling Options
Program Name
JOB1 PAPER/DF C=1
Count: 00
'Live' count of Total Count for
sheets fed in this job run
current collation
R shows the
F731 is ready
The display shows the program selected and the main program options.
To set speed, use the Arrow Buttons until the speed you want is displayed.
You may need to adjust the speed when running booklets or certain paper
finishes.
Blue=EXIT
Number of sheets
in each collated set
ORIENTATION 3
Total: 000000 R... Speed: 100%
OMR status
- see page 2-17
Red=NO
Loading Orientation
Speed selected
DI900/DI950
Inserter signal
confirmation
- see page 2-17
SDC790A