Programming A 'Bcr Standard' Job - Pitney Bowes F731 Operator's Manual

Programming a
'BCR Standard'
Job
SDC790A
Step by Step Instructions
With the feeder ON, press the Green, Blue and Red buttons at the same
time. The display will show:
Select: NEW NON-SCANNING JOB
<-->=SELECT
Press the Arrow Buttons to select 'NEW SCANNING JOB'.
Select: NEW SCANNING JOB
<-->=SELECT
Press the Green button to enter the scanning programming mode. The
display will show the program naming screen:
019> Name of new program : --------
<-->=ALPHA
You can enter a program name up to eight characters long, using any
combination of alpha and numeric characters.
Use the Arrow Buttons until the first character of your program name
appears.
Press the Green button to confirm each character.
When the name is complete, press Red to continue.
The display shows the material selection screen:
019> Material: PAPER/DF
<-->=SELECT
Use the Arrow Buttons to select the material for this job:
Green=Confirm
Green=Confirm
Green=CONFIRM
Green=CONFIRM
Programming • 3
Blue=EXIT
Blue=EXIT
Red=GO ON
Blue=EXIT
3-11