Pitney Bowes F731 Operator's Manual page 33

SDC790A
Push the Material Support Plate
up against each individual batch of
material during the loading process
to support it while you fetch the
next batch.
Important Loading Tips
• When loading the first batch of sheets, do not slide the material in from
the front across the Feed Belts, as this will cause the first couple of
sheets to twist and jam. Instead move the paper from left to right, up to
the Feed Belts. For subsequent batches of material you can slide the
sheets in from the front, between the material already loaded and the
Material Support Plate.
• Once you have completed
the loading process, it is
recommended that you push
the entire paper stack towards
the right using the Material
Support Plate. This will ensure
that the material stack is kept
upright and that all the air is
removed from between the
individual sheets.
If the material is curled along the
top edge, the separation can be
adjusted by rotating the Separator
Adjustment Knob as required.
Rotate the knob anticlockwise for
curled material, but move the knob
in small increments – 2 to 3mm
(approx.. 1/10") maximum.
Operation • 2
2-15