Modifying A Program - Pitney Bowes F731 Operator's Manual

3 • Programming
Modifying a
Program
3-14
With the feeder ON, press the Green, Blue and Red buttons at the same
time. The display will show:
Select: NEW NON-SCANNING JOB
<-->=SELECT
Use the Arrow Buttons to select 'MODIFY JOB'.
Select: MODIFY JOB
<-->=SELECT
Press the Green button to enter the job modify mode.
Use the Arrow Buttons to display the program you want to modify on the
top line of the display. Then press the Green button to select it.
You can now review the job using the Arrow Buttons. You can also edit any
of the following parameters:
• Name of program
• Material
• Loading orientation
• Counter (non-scanning job only)
• Scan line increments (scanning job only)
• Distance – Lead edge to bench mark (scanning job only)
To edit any of these parameters, with the parameter displayed:
• Press the Green button to select the parameter.
• Press the Arrow Buttons to make the change.
• Confirm the change by pressing the Green button.
Green=Confirm
Green=Confirm
Blue=EXIT
Blue=EXIT
SDC790A