Pitney Bowes F731 Operator's Manual page 27

Operation • 2
Top Scanning
Connect power and turn ON. Open the Top Cover.
Open the separator. Unlock lever
a, turn knob b clockwise as far as
it will go and hold in position while
locking lever a.
Press the Green, Blue and Red buttons at the same time to enter the
Menu. Use the Arrow Buttons to select 'User Menu', then press Green to
confirm. Use the Arrow Buttons to select 'BCR Test', then press Green to
confirm.
If your system has more than one BCR scanner, use the Arrow Buttons to
select 'BCR Location', then press Green to confirm. Select the location of
the scanner you wish to test, then press Green to confirm.
Slide a sheet under the separator and observe the scanner beam on the
sheet.
Adjust the scanner side to side until
the marks are centred on the beam
area.
When in 'BCR Test', the scanner
red lights will flash slowly. If the
code is read successfully i.e. the
scanner is correctly aligned, the
lights will flash faster and the
characters read will display on the
operator display.
When the scanner is positioned correctly, exit from the User Menu.
Close the cover.
SDC790A
2-9