2 • Operation
Transport
Material to
Accumulator
Setting the
Accumulator
Side Guides
Accumulator
Ramp
Adjustment
2-12
Lower the Front Cover and turn
knob g anticlockwise to open the
Accumulator Side Guides. Close
the Front Cover.
Load a sheet or booklet.
Press Run Confirm (Green) until
a piece is fed into the accumulator
area.
Raise the F731 Top Cover and
lower the Front Cover.
Rotate knob g clockwise to set the
Accumulator Side Guides. The
correct setting allows approximately
3mm (0.1") overall clearance so
that the material is controlled but
not restricted.
Ensure a piece of material is in
the accumulator area as in the
Accumulator Side Guide setting
above.
Squeeze the tabs e together and
slide the ramp until the yellow
indicators on the ramp align with
the material rear edge.
Close all covers.
SDC790A